Replay From 10.8.0.1 Destination Host Unreachable. The tunnel looks fine and connected to the other side, but seems there is a problem routing traffic through the. As you can see from the details below,.
Jun 19, 2017 at 12:29. Web i can't ping 10.8.0.x from the client or the server. Web my netgear router uses a static ip instead of a dynamic ip.
Web The Server's Tun0 Gets The Ip Address 10.8.0.1 & Client's Tun0 Gets The Ip Address 10.8.0.6.
Web i can't ping 10.8.0.x from the client or the server. Web so many reasons. > > the fact that the client can ping the server means that your basic setup is functioning.
C:\>Ping 10.31.1.125 Pinging 10.31.1.125 With 32 Bytes Of Data:.
Web from 192.168.64.10 icmp_seq=1 destination host unreachable ping: I suppose i just need to add some routes to dom0. There are many possible reasons for getting a “destination host unreachable” error, including things as simple as erroneously connected cables or an overly aggressive firewall.
I Am Not Sure What's.
Web firstly, our support experts confirm whether the host is active using the ping command. When i try to ping at the vpn ip, i get these results: Jun 19, 2017 at 12:29.
Web My Netgear Router Uses A Static Ip Instead Of A Dynamic Ip.
As you can see from the details below,. Bad network cable, icmp echo turned off on the far side, firewall rules, etc. On server, i configured a virtual interface (eth0:0) with a virtual ip (10.168.201.134) for port forwarding.
Web Port Forwarding Settings For Ipcop (Fw) :
Furthermore, that ping attempt doesn't result in. Web since packet forwarding is enabled in the router and the policy of the forward chain is accept (and there are no other rules), i understand that there should be no problem to. The tunnel looks fine and connected to the other side, but seems there is a problem routing traffic through the.